SBG6580 (v8.6.x): LAN Network Setup

How do I configure the LAN Network in the SBG6580? 

By default the SBG6580 functions as a Dynamic Host Configuration Protocol (DHCP) server, allowing it to assign IP’s to all devices connected to the Local Area Network (LAN) Network.  These addresses should be from the address pools that are reserved for local networks. In general, they are of the form "192.168.x.x" or "10.x.x.x".  The SBG6580 includes configurable options for the LAN Network, in which the LAN Network Address can be modified to suit the needs of the network.  This document describes how to change the LAN Network of the SBG6580. 

Requirements: 

• When changing the default LAN subnet, it must start from the range of 192.168.8.x or higher.  
• The LAN IP address used must be a private IP address (within one of the following ranges):
   
  10.0.0.1 - 10.255.255.254 
  172.16.0.1 - 172.31.255.254 
  192.168.8.1 - 192.168.255.254

 

Changing the LAN Network

1. Launch a web browser, such as Internet Explorer, Firefox, or Safari.  Enter http://192.168.0.1 into the address box, and press the Enter key.  The Login page appears.
2. On the Login page:
   a.   Enter admin in the Username field.
   b.   Enter motorola in the Password field.

   c.   Click the Login button.  The Home page appears.

   
   NOTE: On firmware version 8.9.0.4 and later, the default admin password is required to be changed.  The Change User Password prompt will immediately appear after logging into the Web manager with the default admin password.  For assistance with the Change User Password screen, please refer to article # 18055 - SBG6580 (v.8.9.x): Prompt to Change Default Admin Login.
    

   

    
3. Move the mouse-cursor over the Basic tab and select the DHCP sub-link.  The Basic - DHCP page appears.
4. On the Basic - DHCP page:
   a.   LAN IP Address - Enter the desired IP address for the LAN interface here.  

   b.   Enable DHCP Server - Leave at default, Enabled.

   c.   Starting Local Address - Leave at default 2, or enter the first IP address to be used in the DHCP range.

   d.   Max Number of Network Devices - Leave at default, or enter the number of IP addresses to be used in the DHCP range.  For example, if this option is set to 100, and the Starting Local Address is set as 192.168.8.100, then the DHCP range will be from 192.168.8.100 - 192.168.8.199.

   e.   Lease time - Leave at default, or enter the amount of seconds that a device will keep an IP address, if that device has received an IP address automatically from the SBG6580.

   f.   Click the Apply button.

   
   NOTE: If the LAN IP address is modified to be in a different subnet (e.g. 192.168.8.1), the SBG6580 will automatically change the DHCP range to use addresses in that subnet.
    
   
    
5. The following message will appear (below) when the SBG6580 is restarting. Close the Browser.   
    
   NOTE: Please allow 2 minutes for the SBG6580 to re-establish connection. 
    
   
    
6. To access the GUI, open a new web browser and enter the new address http://192.168.8.1 into the address box, and press the Enter key.  The Login page appears.