SBR-AC1900P: Installation on FiOS Service

• Before the Installation
• Testing Internet Connection
• Install the SBR-AC1900P on FiOS Service

• Active FiOS Internet service
• Ethernet cable Internet connection
  
  NOTE: Consult with the service provider to see if the SBR-AC1900P is suitable for usage.

Verify that the following items were included with the ARRIS SBR-AC1900P wireless router.  The SBR-AC1900P, power supply and Ethernet cable are necessary to perform the installation. 

NOTE: The quick start guide and warranty card can be downloaded from www.arris.com/consumers. 
 

• Wi-Fi Router
• Power Cable
• Wireless Installation Guide
• Ethernet Cable
• End User License Agreement

1. Without disconnecting the existing network, power on a computer. 
    
2. Open a web browser on the computer (such as Internet Explorer, Google Chrome, Firefox. or Safari).
    
3. Enter the address http://www.surfboard.com in the address bar and press the Enter key. 
   
   NOTE:  If the Internet is not accessible, please contact the service provider to setup Internet service.

1. Disconnect the existing Ethernet cable with Internet connectivity and connect the blue Ethernet cable (included) to the Ethernet port of the ONT or Ethernet wall outlet.
   
   NOTE: The existing Ethernet cable with Internet connectivity can be used instead of the blue Ethernet cable to connect to the SBR-AC1900P.
    
2. Connect the other end of the blue Ethernet cable to the blue WAN port on the rear of the SBR-AC1900P.
    
3. Connect the power cord to the rear of the SBR-AC1900P and plug it to an available electrical wall outlet.  Allow 30 seconds for the Front Panel Primary LED to become solid green. 
   
   NOTE 1:  If the Front Panel Primary LED is flashing green make sure both ends of the blue Ethernet cable is securely connected between SBR-AC1900P and ONT or try using another Ethernet cable. 
   
   NOTE 2: If the Front Panel Primary LED is flashing green, power cycle the SBR-AC1900P.  If the Front Panel Primary LED continues to flash contact the service provider to troubleshoot the Internet connection.
    

   LED	Color/Behavior	Description
   Front Panel Primary LED  Connection status	Solid green	Wi-Fi router is connected to the modem
   	Flashing green	No connection to the Internet or the modem
   	Flashing red	Start-up mode, or error

4. Connect a Ethernet cable from one of the four white Ethernet ports on the rear of the SBR-AC1900P to the Ethernet port of a laptop or desktop.  For wireless devices, establish to open wireless network list and connect to SURFboard-XXXX (see SSID number listed on the router label). 
   
   
    
5. To test Internet connection launch a web browser, such as Internet Explorer, Firefox, or Safari.  Enter www.surfboard.com into the address box, and press the Enter key.  The ARRIS website should open.