ARRIS Consumer Care

mAX Routers: Port Forwarding Setup

« Go Back

Information

Article Number	000023673

Title	mAX Routers: Port Forwarding Setup

URL Name	mAX-Routers-Port-Forwarding-Setup

Summary	mAX Routers: Port Forwarding Setup

Validation Status	Validated

Keywords

Dash, WC4T, W31, W30, W21 app, central, SURFboard, mAX, Plus, (AX7800), Pro, (AX11000), iOS, Android, ports, NAT, strict, open, xbox, playstation, PS3, Port Forwarding, gaming, W61, W161

Question

How do I configure Port Forwarding in my mAX Router?

Answer

NOTE: This article applies to the mAX WC4S, WC4T, W21, W121, W122 Express, W30, W130, W31, W133, W61, and the W161 Routers.

Port Forwarding allows the option to run a publicly accessible server on the home network by specifying the mapping of TCP and/or UDP ports to a local device. This enables incoming requests on specific port numbers to reach devices such as Web Servers, Mail Servers, Digital Video Recorders (DVR), and gaming devices.
Port Forwarding is set up by entering specific port(s). This document contains the following sections:

Port Forwarding Setup
Remove Port Forwarding Rule

Requirements

Client device IP Address
The port number(s) and protocol (TCP and/or UDP) of the service

After completing the port forwarding setup, it is recommended to reserve the IP address of the client device that was set up for port forwarding. Please refer to article 23901 - mAX Routers: LAN IP Reservation Setup.

Port Forwarding Setup

Tap the My Devices box.
Locate the client device to be used for port forwarding and tap + button to expand the card (e.g. the Laptop device was used).
Copy the client device's IP Address under the IP Address section to use for the port forwarding setup.
Tap the My Network icon at the bottom of the screen.
Tap the Network Management box.
Tap the Network Settings + button to expand the card, then tap the General Settings link.
Tap the Port Forwarding link.
Tap the Add Rule button.
On the Add Port Forwarding Rule pop-up box, enter the name of the service in the Port Forwarding Rule name field.
Tap the TCP/UDP box Protocol option.
Enter the same port number into both the Enter Internal port start and Enter Internal port end fields.

NOTE: When forwarding a range of ports, enter the start and end of the port range in the two fields.
Enter the same port numbers that were previously entered in Enter External port start and Enter External port end fields.
Enter the client's IP address in the Enter Internal IP address field.
Tap the Save Changes button.
The port forwarding rule will appear as shown. Repeat steps 8 - 14 to forward additional ports.

NOTE: To edit the port forwarding entry tap the Pencil icon.